Home / Texture Matching
Drywall Texture Matching in Tooele
Cut out the damage. Fill. Sand. Prime. Text a photo to start.
Call 435-534-6845 or text us.
The problem
A patch can be flat and still stick out. Light hits a raised texture differently than a smooth patch. The eye reads the difference. Trades call it flashing.
Texture matching hides it. We copy the pattern, the spray size and the sheen of the wall around the repair.
Finishes we match
- Knockdown: splatter that is flattened with a knife
- Orange peel: fine, even bumps, like fruit skin
- Smooth or skim: flat, tight walls
- Light sand-swirl and hand-troweled finishes
- Ceiling spray textures, where the product allows
How we match
- Look at the wall in raking light. Note bump size and spacing.
- Test a sample on cardboard. Compare in the same light.
- Spray or stipple the texture over the patch. Feather past the edge.
- Wait the right time for knockdown, then flatten it.
- Let it dry. Prime so the texture takes paint evenly.
- Paint the full wall. A new finish under old paint still shows.
Tooele homes and texture
We do not claim which texture is most common in Utah. We read your wall instead. Local points:
Tooele grew in waves. Subdivisions from different years used different crews. Next-door homes can have different finishes, so we match your wall, not a neighborhood.
Census-based data puts the median build year in the 1990s. Knockdown and orange peel came into wide use in that era nationally. Both are among the finishes we see.
The city dates to 1851, and new homes keep being built. An older wall near Main Street can carry hand finishes that spray cans do not copy. We check before we start.
What to send us
- A wide photo of the wall
- A close photo with light from the side
- A short video turning a phone flashlight across the wall
- Notes on room and wall: ceiling, hall, stairwell
Limits
Texture is hard to match exactly. Old texture ages and yellows. New texture is sharper. We blend the edge and repaint the wall so the join disappears. We do not promise an invisible patch under every light.
Mistakes that make patches flash
- Spraying texture too heavy, then leaving it raised
- Knocking down too early or too late
- Skipping primer, so the patch soaks paint
- Painting the patch only
- Matching the pattern but not the sheen
Paint is the last step
Texture and paint work together. We prime the texture. Then the wall gets a full coat, corner to corner, in one sheen. Old paint and new paint dry differently, so a full wall coat hides the join.
Ceiling textures, step by step
- Mask the walls, floor and light fixtures.
- Test the spray on cardboard and match the drop size.
- Feather the texture outward from the patch.
- Let it set. Check in side light.
- Prime the whole patch zone.
- Paint the ceiling edge to edge.
Wall textures you may find
Slap brush, skip trowel and sand-swirl show up on older walls. They are hand finishes. We copy the motion and spacing with a brush or trowel.
Smooth walls need a skim coat and fine sanding. A patch with any texture on a smooth wall stands out.
Quick answers
Why does my patch show up after painting?
The patch surface is flat or sprayed at a different size than the wall. Light shows it.
Can you match a ceiling?
Yes, in most cases. Ceilings take extra masking and a lighter spray.
What is the difference between knockdown and orange peel?
Knockdown has flat-topped blotches with low valleys. Orange peel has small, rounded bumps.