Skip to content

Home / Leak and Water Damage

Drywall Leak and Water Damage Repair in Tooele

Cut out the damage. Fill. Sand. Prime. Text a photo to start.

Call 435-534-6845 or text us.

Do this first

Stop the water. Shut the valve, tarp the roof, call the plumber or roofer. We repair drywall after the source is fixed. Drywall dries slowly and wet board keeps getting worse.

Wet drywall goes soft, sags, stains and crumbles. Wet board is cut out and replaced. We do not paint over it.

Where the water comes from

  • Supply line or drain line leaks in a wall or ceiling
  • Roof leaks that stain a ceiling in a ring
  • Window leaks, with staining under the sill
  • Water heater and appliance overflows
  • Condensation around vents and cold walls

What we do

  1. Confirm the leak is stopped. We do not work under an active drip.
  2. Probe the board. Push test with a screwdriver tip.
  3. Mark the damage past the stain. Wet board often reaches further than the ring.
  4. Cut out wet, soft and damaged board.
  5. Hang new board. Tape and finish the seams.
  6. Seal the stain with stain-blocking primer. Match texture. Prime for paint.

Tooele conditions to know

Tied to Tooele and to the board you are looking at.

Spring moisture.

NOAA normals for 1991-2020 show May as Tooele's wettest month, near 18 inches of precipitation yearly. Roof and window leaks tend to show up as ceiling stains after wet spells and snowmelt.

Homes from the 1990s on.

Census-based median build year data lands in the 1990s. Original roofs, supply lines and water heaters are old enough that failures happen. Check them while the wall is open.

An older core near Main Street.

Tooele was settled in 1851 and incorporated in 1853. Older houses near the center may hold older plumbing and older wall materials. We check what the wall is made of before we cut.

Groundwater-based supply.

The city publishes annual water quality reports. For a leak, the type of water does not change the repair. Wet board comes out either way.

On mold

We do not remediate mold and we do not test for it. If you see black or green growth, smell mustiness, or the board stayed wet for days, bring in a qualified specialist. We remove and replace board after that step is cleared.

Before we arrive

  • Shut off the water at the source
  • Place a bucket under a sagging ceiling. Poke a small hole only if a plumber or roofer says it is safe
  • Move furniture and cover floors
  • Photograph the stain from three angles
  • Call your insurer if you plan a claim. Keep photos

Signs the board is finished

  • Sags between the studs
  • Soft when pressed with a screwdriver
  • Paper face bubbled or peeling
  • Brown ring larger than a hand, still growing
  • Crumbly edge when you tap it
  • Musty smell that does not fade

Dry first, repair second

  1. Fix the source.
  2. Open the damaged area so air reaches the cavity.
  3. Wait until board and framing feel dry. A specialist can measure it.
  4. Replace what is damaged.
  5. Prime with stain blocker before paint.

Quick answers

Can you just paint over a water stain?

No. The stain bleeds through paint, and the board under it may be soft.

How do you know the board is ruined?

Soft, crumbly, sagging, bubbled or musty board is done. Dry, firm board can sometimes stay.

Do you find the leak?

No. We repair the damage. A plumber or roofer finds and fixes the source first.

Do you handle mold?

No. A qualified specialist should test and advise on suspected mold.

Other repairs we do

Damaged wall in Tooele? Send a pic and we plan the repair.

CallText us